| Pump design | Fixed- or variable-displacement; vane, gear, or piston design | Confirm the replacement suits the circuit’s control method and duty. A different design is not automatically interchangeable. |
| Displacement | Pump volume per revolution, usually stated in cm³/rev | Match the original displacement or verify that the resulting flow meets the system requirement. |
| Flow rate | Required delivery in L/min at the operating speed | For theoretical flow: displacement (cm³/rev) × speed (rpm) ÷ 1,000 = L/min. Account for volumetric efficiency when estimating actual flow. |
| Pressure rating | Continuous and intermittent or peak pressure, typically in MPa or bar | The replacement’s ratings must meet or exceed the application’s specified pressures. Do not use a peak rating as a continuous rating. |
| Operating speed | Minimum and maximum permissible shaft speeds, in rpm | Check the full motor speed range, including start-up conditions, against the pump’s rated limits. |
| Rotation direction | Clockwise, counterclockwise, or reversible; confirm the viewing reference | Compare the specified direction when viewed from the shaft end. Incorrect rotation can prevent proper operation or damage the pump. |
| Mounting and shaft | Mounting style, bolt pattern, pilot diameter, shaft type, diameter, and length | Check dimensioned drawings and coupling engagement. Similar-looking pumps may have incompatible mounting or shaft dimensions. |
| Port connections | Inlet and outlet locations, port size, thread type, and sealing method | Match the hydraulic connections and verify that inlet plumbing is suitable for the pump’s flow and suction requirements. |
| Control configuration | Pressure, flow, load-sensing, or other control arrangement, where applicable | For controlled or variable-displacement units, verify the control type, settings, and hydraulic connections—not only the pump’s main ports. |
| Hydraulic fluid | Fluid type, viscosity range, temperature range, and cleanliness requirements | Confirm the pump is rated for the system fluid and operating conditions, and follow the equipment manufacturer’s filtration requirements. |
| Installation envelope | Overall dimensions, clearance, weight, and service access | Check the available space and ensure the replacement can be installed without stressing pipes, couplings, or mounting surfaces. |