| Product specification | Confirm the tantalum grade, sheet or plate form, thickness, width, length, condition, and quantity against the purchase specification. | Quotation and order confirmation listing each required product detail. | Accept only a quotation that identifies the material and dimensions clearly; resolve any substitutions or unspecified conditions before ordering. |
| ASTM B708 compliance | Check whether the order requires ASTM B708, the ASTM specification for tantalum and tantalum alloy plate, sheet, and strip. Confirm the applicable grade and edition in the contract. | Written compliance statement and a material test report tied to the supplied lot. | Compare the report and order requirements with the edition and grade specified in the contract. A general claim of “ASTM compliant” is not a substitute for lot-specific documentation. |
| Mill Test Report (MTR) | Verify that the report identifies the material grade, heat or lot number, product form, dimensions, test results, and applicable specification. | Sample MTR before purchase; final MTR for the shipped material. | Check that the reported values and product identifiers are complete and consistent with the purchase order and packing documents. |
| Chemical composition | Review the reported elemental analysis against the limits for the specified grade and applicable standard requirements. | Heat-analysis results included in the MTR, with the grade and heat number identified. | Do not compare results with a different grade or edition. Request clarification if units, limits, or test basis are not stated. |
| Mechanical properties | Confirm that required mechanical tests and acceptance criteria match the specified grade, product condition, and order requirements. | Applicable test results in the MTR or an associated, lot-linked test report. | Check that test results are reported where required by the specification or purchase order; do not assume identical requirements for every grade or condition. |
| Traceability | Determine whether material can be traced from the heat or lot through processing, inspection, packing, and shipment. | Heat or lot number on the MTR and packing list, plus a documented marking or identification method for the delivered material. | Verify that identifiers match across documents and remain associated with the material after cutting or repacking, where applicable. |
| Dimensions and tolerances | Check thickness, width, length, flatness, and dimensional tolerances against the drawing, order, or agreed specification. | Inspection record showing measured dimensions and the measurement method or inspection basis. | Agree on tolerances and inspection requirements before production; compare recorded measurements with those agreed values. |
| Surface condition | Define acceptable surface condition, finish, and handling requirements for the intended application. | Product inspection criteria and, where useful, photographs or a pre-shipment inspection record. | Use written acceptance criteria rather than relying only on general descriptions such as “good surface” or “bright finish.” |
| Inspection and nonconformance control | Ask how inspection findings, rejected material, and corrective actions are recorded and communicated. | Inspection procedure, relevant quality records, and a documented process for handling nonconforming product. | Check that issues can be linked to the affected lot and that corrective actions are documented when needed. |
| Document consistency | Cross-check the quotation, purchase order, MTR, inspection record, packing list, and shipping documents. | A complete document package for the quoted or shipped lot. | Resolve differences in grade, dimensions, quantities, specification, or heat and lot identifiers before accepting the shipment. |