| 1 | General-purpose multichannel isolator | Multiple digital channels with fixed or configurable input-to-output directions | GPIO, control lines, status signals | A flexible option for transferring logic signals between circuits that must remain galvanically isolated. | Channel count and direction, logic-level compatibility, propagation delay, isolation ratings, and package footprint. |
| 2 | SPI signal isolation | Typically three controller-to-peripheral signals and one peripheral-to-controller signal for a standard four-wire SPI connection | SCLK, MOSI, chip select, and MISO | Separates SPI-connected controllers and peripherals while preserving the interface’s clocked data paths. | Data rate, channel direction, timing skew, clock polarity and phase requirements, and the number of chip-select lines. |
| 3 | UART signal isolation | Usually one transmit and one receive channel for a full-duplex link | UART TX and RX | Can isolate serial communications used in embedded control, instrumentation, and service ports. | Baud-rate needs, channel direction, idle-state behavior, logic levels, and whether flow-control signals also need isolation. |
| 4 | I²C-compatible isolation | Two bidirectional open-drain signal lines, typically using circuitry designed for bidirectional operation | SDA and SCL | Allows an I²C bus to cross an isolation barrier; ordinary fixed-direction channels are not automatically suitable for this function. | Bidirectional operation, pull-up voltage and current limits, bus capacitance, clock stretching, and supported bus speed. |
| 5 | Isolated RS-485 interface design | Digital isolator channels paired with an RS-485 transceiver, or an integrated isolated transceiver | UART-side transmit, receive, and driver-enable signals; differential bus on the transceiver side | Isolation can help separate the controller from a long-distance or electrically noisy field bus. A digital isolator alone does not drive an RS-485 cable. | Confirm whether the transceiver is included; check bus speed, node loading, termination, fail-safe behavior, isolation ratings, and applicable approvals. |
| 6 | PWM and power-control signal isolation | One or more unidirectional control channels | PWM, enable, fault, and gate-control signals | Transfers control signals across a barrier in switching-power and motor-control systems. | Propagation delay, pulse-width distortion, common-mode transient immunity (CMTI), output drive needs, and fault-state behavior. |
| 7 | Encoder and position-feedback isolation | Several channels for phase and index signals, with direction selected to match the system | Quadrature A/B signals and index pulses | Helps isolate digital feedback signals between a sensor or drive and a controller. | Maximum signal frequency, channel-to-channel timing, input thresholds, cable noise, and any required filtering. |
| 8 | ADC and data-acquisition link isolation | Channels arranged to match the converter’s serial data, clock, and control paths | SPI or other digital converter signals | Can isolate digital communication between a converter and its host while keeping the signal paths separate from the analog measurement domain. | Interface timing, channel direction, converter throughput, noise and layout requirements, and the isolation needs of the complete measurement system. |
| 9 | Isolated sensor-bus connection | Channels selected for the sensor interface; bidirectional buses require compatible isolation circuitry | I²C, SPI, or digital sensor outputs | Useful when sensors and processing electronics operate in different electrical domains. | Sensor protocol, supply and logic levels, bidirectional requirements, bus speed, and whether isolated power is also needed. |
| 10 | Low-power, space-constrained GPIO isolation | One or a few digital channels in a compact package | Wake, interrupt, enable, and low-speed status signals | Provides isolation for a small number of signals where board area or power consumption is a priority. | Quiescent and switching power, package size, channel count, default output state, and required safety documentation. |