| Cleanable floor area | Measure the floor area the machine can actually access, excluding shelving, fixed equipment, and restricted zones. | Record the accessible area in square metres or square feet for each cleaning zone; calculate the required coverage per shift. | Coverage needs depend on the layout, route, cleaning method, and time available—not just the building’s total floor area. |
| Floor surface | Identify materials such as sealed concrete, vinyl, ceramic tile, or polished hard flooring, and note transitions between surfaces. | Document each surface type and check that the proposed machine and cleaning method are approved for it. | Brushes, pads, water use, and traction requirements vary by surface; an unsuitable method can damage floors or clean poorly. |
| Soil and debris | List common materials, such as dust, grit, packaging fragments, food residue, or liquid spills, and estimate how often they occur. | Separate routine dry debris from sticky soils and liquid spills; test representative areas before selecting a machine. | Different cleaning tasks may require sweeping, scrubbing, or manual spill response. A single machine may not suit every task. |
| Cleaning frequency | Define how often each area must be cleaned and which areas need extra attention. | Set a schedule by zone, such as several passes per day in busy entrances and a daily pass in lower-traffic areas. | A zone-based schedule helps match machine capacity and battery availability to actual cleaning demand. |
| Operating window | Identify available cleaning hours, quiet periods, shift changes, and times when people or vehicles occupy the floor. | Specify the start and finish time for each cleaning run, including time for travel, setup, and servicing. | Autonomous operation is only useful when routes can run safely within the site’s operating schedule. |
| Traffic and shared spaces | Assess pedestrian density, forklifts, carts, doorways, and areas where people frequently cross the route. | Map high-traffic crossings and establish operating rules for occupied aisles and shared work areas. | Obstacle detection and route planning can reduce interruptions, but they do not replace site traffic controls or supervision. |
| Aisle and access dimensions | Measure narrowest aisles, door openings, turning areas, ramps, and floor-level changes. | Compare measured clearances with the machine’s published dimensions and turning requirements; include a safety margin. | The cleaner needs enough space to travel, turn, dock, and pass safely without blocking access or contacting equipment. |
| Battery and coverage capacity | Estimate route duration and check the machine’s rated run time under the intended cleaning conditions. | Require a full route plan that includes travel time, cleaning speed, charging, and any planned battery changes. | Published run time and coverage figures can vary with floor conditions, settings, route complexity, and operating practices. |
| Water and waste handling | Check clean-water filling, recovery-tank emptying, drainage access, and the location of service areas. | Confirm that tank capacity and service intervals fit the planned route, or schedule stops at suitable refill and disposal points. | Frequent servicing can interrupt cleaning. Wastewater should be handled according to site procedures and applicable rules. |
| Navigation and mapping | Review map setup, route editing, restricted zones, temporary obstacles, and recovery from blocked paths. | Test the intended routes during normal site conditions, including doors, people, and movable equipment. | Real-site testing shows whether autonomous navigation works reliably in the actual layout, not just in an empty space. |
| Safety and compliance | Review emergency stops, warning indicators, obstacle response, data handling, and applicable workplace requirements. | Complete a documented risk assessment and confirm that training and operating procedures are in place before deployment. | Site-specific safety controls are essential wherever the machine shares space with employees, visitors, or vehicles. |
| Reporting and oversight | Decide which records supervisors need, such as completed routes, exceptions, cleaning time, and service alerts. | Define the required reports and how often managers will review them. | Useful reporting helps verify that planned cleaning is completed and highlights areas that need route or schedule changes. |
| Maintenance and support | Estimate staff time for daily checks, brush or squeegee care, tank cleaning, and troubleshooting. | Request a maintenance schedule, consumable list, training plan, and local service response details before purchase. | Routine care and accessible support affect uptime and the total effort required to keep the cleaner in service. |